 |
Impact Racing, Inc.’s new SXS helmet is a feature rich, DOT rated full-face helmet. The helmet features an easy to use, flip up shield with multi-position detents, and a removable-washable inner liner. An easy to use lever actuated chin strap buckle makes for easy and secure latching. The helmets are fully vented, with adjustable chin-bar mounted air intakes that allow for full adjustability of airflow.
The included, clear poly-carbonate shield provides protection from debris, with replacement shields available in Clear, Dark-Tint, and Silver-Chrome. The SXS helmets can be ordered with additional options installed, such as helmet skirts and communication systems by PCI or Rugged Radios. The SXS helmets is DOT compliant making it legal for use in the state of CA for off-road vehicle use. Not for competition use.
- Please carefully read, understand and adhere to the following information. Since your helmet is engineered to very exacting standards, correct care is vital to its proper functioning.
SHIELD HARDWARE: to insure proper shield fit and function, it is important to check the tightness of the shield pivot and shield positioning screws before every use. Tighten until screws are firmly seated, careful to not over tighten.
HELMET CHEEK FIT PADS: to change, remove or replace cheek fit pads, turn the helmet upside down and place thumb under cheek pad and ‘pinch’ thumb with fingers on exterior shell. This will prevent separating and helmet upholstery from the shell as you remove the cheek fit pad. With free hand, slowly pull the cheek fit pad away from the hook and loop interior starting at the corner. Replace with new cheek pad.
HELMET INNER LINER: after a race, wet fit pads and liner should be dried in the shade using a fan.
MINI CHAMP & VAPOR HELMET INSERTS: The helmet comes from the factory as a size large without an insert. To place insert into the helmet perform the following: Hold Helmet with base opening facing you. Carefully fold back hat band upholstery toward you around the entire circumference of the helmet. Insert a Quick-Fit insert at the rear of helmet first and continue to push insert in and smooth insert down around the entire crown of the helmet. Fold hat band liner back into position.
HELMET HARDWARE: all fastening hardware and straps should be checked regularly for strength and security. Keeping all components of the helmet clean and well cared for is very important. Even perspiration can compromise the effectiveness of the hardware and straps.
|
|
|